ADG 6.5 SAUM Brass

PRE ORDER ***WILL SHIP END OF FEB 2024***

ADG 6.5 SAUM (Short Action Ultra Mag) brass was designed not only for consistency, but for durability. One of the ways ADG accomplished this was adding material to the case in specific areas to strengthen it. With the additional material, ADG brass is heavier than most other manufacturers brass and therefore will require lower charge weights to achieve the same pressures and velocities due to the reduced volume inside the brass. ADG recommmends using a reputable load data source and working up from their recommended minimum starting loads. Failure to reduce charge weights established using other manufacturers brass will likely result in higher pressures and velocities while using ADG 6.5 SAUM brass and may result in unsafe pressure levels. Ships in its own hard, flip top case. You may take out the foam insert used to protect the brass during shipment and use the box to transport loaded rounds to the range. All brass is tracked with a custom lot number for quality control which is located on the underside of the box.

We recommend reducing any existing charge weights by 10% and re-developing your specific load when replacing any component in a load recipe with a new component (brass, projectile, primer, or powder type).  Failure to reduce charge weights established using other manufacturers brass may result in higher pressures and velocities while using ADG brass and may result in unsafe pressure levels.

• Caliber- 6.5mm
• Finish- Standard
• Quanity- 50 count
• Case weight- 213.9 grains (average)
• Case volume- 73.0 grains/H2O (average)
• Neck wall thickness- .0138 inch (average)

ADG Premium brass was designed not only for consistency, but for durability. One of the ways we accomplished this was adding material to the case in specific areas to strengthen it. With the additional material, our brass is heavier than most other manufacturers brass and therefore will require lower charge weights to achieve the same pressures and velocities due to the reduced volume inside the brass. We recommend using a reputable load data source and working up from their recommended minimum starting loads. Failure to reduce charge weights established using other manufacturers brass will likely result in higher pressures and velocities while using ADG Premium brass and may result in unsafe pressure levels. We recommend reducing any existing charge weights by 10% and re-developing your specific load when replacing any component in a load recipe with a new component (brass, projectile, primer, or powder type).

No reviews have been written for this product.

Write a Review